UTC TruVision IP Dome Uživatelský manuál stáhnout pdf (Strana 34)

3BChapter 4: Configuring the camera

30 TruVision IP Dome Open-Standards User Manual

Alarm parameters

Use this menu to select how external alarm inputs and alarm outputs should be

handled.

Figure 14: Alarm input screen

To set up an external alarm input:

1. In the “Alarm Parameters” folder click the Alarm Input subfolder to open its

screen.

2. Select one of the two external alarm inputs from the Alarm input drop-down

list, A1 or A2.

3. Select the input type in the Relay status box.

Alarm input type refers to the sensor type. You can select Normal Open (NO)

or Normal Close (NC). NO is default.

Note: In order for a camera to record an alarm, the recording schedule and

alarm type must be enabled. See “Defining a recording schedule” on page 34

for further information.

4. Select how you want to be notified of an external alarm.

Check one or more of the following response methods:

Email link

Sends an e-mail to a specified address when there is a

motion detection alarm. No attachment can be sent with the e

mail.

See “Network parameters” on page 23 for information on

setting up the e-mail link.

Trigger alarm output

Triggers the camera’s alarm output. Up to two alarm outputs

can be selected.

Trigger recording

Triggers the recording to start in the camera.

Note: Only available for cameras with an SDHC card.

5. Click Save to save changes.

Note: The camera will prompt you to reboot in order for the schedule changes to

take effect.

1 2 ... 29 30 31 32 33 34 35 36 37 38 39 ... 65 66

Žádné komentáře

UTC TruVision IP Dome Uživatelský manuál Strana 34