UTC TruVision IP Dome Uživatelský manuál stáhnout pdf (Strana 29)

2BChapter 3: Network and streaming configuring

TruVision IP Dome Open-Standards User Manual 25

To define the network parameters:

1. In the “Network Parameters” folder click the Network setting subfolder to

open its screen.

From the NIC Type drop-down list, select the required value. Enter the values

for the IP address, subnet mask, gateway, DNS server and HTTP port. Click

Save to save changes.

2. Click the PPPoE setting subfolder to open its screen and check Enable

PPPoE. Enter the user name and password. Click Save to save changes.

3. Click the DDNS setting subfolder to open its screen and check Enable

DDNS. Enter either IP server or DynDNS as protocol.

If DynDNS is selected, enter the user name and password registered to the

DynDNS web site. The domain name is that of the DynDNS web site. Click

Save to save changes and return to the “Network settings” menu.

4. Click the E-mail setting subfolder to open its screen and enter the SMTP

server, SMTP port, user name and password and the e-mail sender and

receiver addresses. Click Save to save changes.

Serial port settings

Use the “Serial setting” folder to define the RS-232 and RS-485 communication

settings.

If a PTZ camera is connected to this camera, the RS-485 settings must be the

same as the PTZ protocol used.

1 2 ... 24 25 26 27 28 29 30 31 32 33 34 ... 65 66

Žádné komentáře

UTC TruVision IP Dome Uživatelský manuál Strana 29